Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE PRESSURE RELIEF VALVE

(a) Remove the pressure relief valve and O-ring.

(a) Remove the pressure relief valve and O-ring.

2. REMOVE MAGNET CLUTCH ASSEMBLY

(a) Secure the cooler compressor assembly in a vise between aluminum plates.

(a) Secure the cooler compressor assembly in a vise between aluminum plates.

(b) Using SST, hold the magnet clutch hub.

SST: 09985-00260

(c) Remove the bolt, magnet clutch hub and compressor spacer.

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.

(d) Using a snap ring expander, remove the snap ring and magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.

(e) Remove the screw.

(f) Disconnect the connector.

(g) Using a snap ring expander, remove the snap ring and magnet clutch stator.

3. REMOVE COMPRESSOR PICK UP SENSOR

(a) Disengage the clamp.

(b) Remove the 3 screws and compressor pick up sensor.

Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make ...

Inspection
INSPECTION PROCEDURE 1. INSPECT MAGNET CLUTCH ASSEMBLY (a) Inspect the magnet clutch assembly. Text in Illustration *a Component without harness c ...

Other materials:

Heater Circuit (C1AAE)
DESCRIPTION The forward recognition camera controls the current supplied to the camera heater (forward recognition hood). If the forward recognition camera detects a malfunction in the camera heater (forward recognition hood) circuit, DTC C1AAE is stored. DTC No. Detecti ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Smart Key System DTC Code Detection Item See page B27A1 Open in Driver Side Electrical Antenna Circuit B27A5 Open in Front Floor Electrical Key Oscillator Circuit ...

Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a +B short in the blind spot monitor indicator RH. DTC Code DTC Detection Condition Trouble Area C1AB1 With the blind spot monitor main switch assembly (warni ...

2015-2022 © Copyright www.luting.site