Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Front Blower Motor

Inspection

INSPECTION

PROCEDURE

1. INSPECT BLOWER MOTOR

(a) Inspect the blower motor.

(1) Connect the positive (+) lead from to terminal 1 and negative (-) lead to terminal 2, then check that the motor operates smoothly.

CAUTION:

  • Use safety glasses
  • Do not use battery power, use DC power supply (30 A).
  • Do not operate the motor and fan assembly at over 5 V.
  • Be sure to hold the motor in a stable and safe way.

If the result is not as specified, replace the blower motor.

Installation
INSTALLATION PROCEDURE 1. INSTALL COOLER CONDENSER ASSEMBLY (a) Engage the 2 claws to install the 2 condenser upper brackets. (b) Engage the 2 claws to install the 2 condenser lower brackets. ...

Front Blower Resistor
Inspection INSPECTION PROCEDURE 1. INSPECT BLOWER RESISTOR (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance ...

Other materials:

Certification ECU Vehicle Information Reading/Writing Process Malfunction (B15F7)
DESCRIPTION This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen. HINT: The certification ECU (smart key ECU assembly) controls the smart key system related items that are custo ...

Initialization Switch (for Test Mode DTC) (C2198/98)
DESCRIPTION During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals. DTC No. DTC Detection Condit ...

Open in Bus 5 Main Bus Line
DESCRIPTION There may be an open circuit in one of the CAN main bus lines when the resistance between terminals 15 (CA5H) and 16 (CA5L) of the central gateway ECU (network gateway ECU) is 70 О© or higher. Detection Item Trouble Area Resistance between ter ...

2015-2022 © Copyright www.luting.site