Toyota Tacoma 2015-2018 Service Manual: HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)

Toyota Tacoma 2015-2018 Service Manual / Navigation / Multi Info Display / Navigation System / HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC No.	DTC Detection Condition	Trouble Area
B1551	When one of the conditions below is met: "HD Radio" tuner decoder malfunction "HD Radio" tuner audio output section malfunction "HD Radio" tuner decoder RF/IF malfunction	Navigation receiver assembly
B15A0	When either condition below is met: Bus malfunction EEPROM error
B15AD	When one of the conditions below is met: Short to ground or +B, or open occurs in gyro signal circuit Gyro sensor malfunction GPS receiver malfunction
B15B0	Picture circuit (TFT unit) malfunction
B15B3	When one of the conditions below is met: AM tuner PLL is unlocked FM tuner PLL is unlocked Tuner malfunction
B15B4	When one of the conditions below is met: Mechanism drive signal malfunction Load/Eject malfunction Read mechanism malfunction Mechanical malfunction
B15B7	"Bluetooth" module malfunction

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again. ).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE NAVIGATION RECEIVER ASSEMBLY

LVDS Signal Malfunction (from Extension Module) (B1532,B156C)

DESCRIPTION DTC Code DTC Detection Condition Trouble Area B1532 When one of the conditions below is met: Video signal (digit ...

Extension Module Malfunction (B1552,B158A,B15BA)

DESCRIPTION These DTCs are stored when a malfunction occurs in the extension module. DTC Code DTC Detection Condition Trouble Area B1552 ...

Other materials:

Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes. (e) Check for details of the DTCs. Click here CLEAR DTC (a) Connect the Te ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT DISC (a) Align the matchmarks of the front disc and the front axle hub and install the front disc. Text in Illustration *a Matchmark HINT: When replacing the disc with a new one, se ...

Initialization
INITIALIZATION 1. RESET MEMORY NOTICE: Perform Reset Memory (AT initialization) when replacing the automatic transmission assembly, transmission valve body assembly or any of the shift solenoid valves. Reset Memory can be performed only with the Techstream. HINT: The E ...