Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

(a) Using a dial indicator, measure the inside diameter of the front oil pump body sub-assembly bushing.

Maximum inside diameter:

38.138 mm (1.50 in.)

If the inside diameter is more than the maximum inside diameter, replace the front oil pump body sub-assembly.

2. INSPECT STATOR SHAFT ASSEMBLY

(a) Using a dial indicator, measure the inside diameter of the stator shaft assembly bushing.

Maximum inside diameter:

22.227 mm (0.875 in.)

If the inside diameter is more than the maximum inside diameter, replace the stator shaft assembly.

3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY

(a) Push the front oil pump driven gear to one side of the front oil pump body sub-assembly.

(b) Using a feeler gauge, measure the clearance.

Standard body clearance:

0.10 to 0.17 mm (0.00394 to 0.00669 in.)

If the body clearance is more than the standard clearance, check the front oil pump drive gear, front oil pump driven gear and front oil pump body sub-assembly.

(c) Using a feeler gauge, measure the clearance between the front oil pump driven gear teeth and the front oil pump drive gear teeth.

Standard tip clearance:

0.07 to 0.15 mm (0.00276 to 0.00590 in.)

If the tip clearance is more than the standard clearance, check the front oil pump drive gear, front oil pump driven gear and front oil pump body sub-assembly.

(d) Using a steel straightedge and a feeler gauge, measure the side clearance of both gears.

Standard side clearance:

0.03 to 0.05 mm (0.00118 to 0.00196 in.)

If the side clearance is more than the standard thickness, check the front oil pump drive gear, front oil pump driven gear and front oil pump body sub-assembly.

4. INSPECT OIL PUMP DRIVE GEAR ROTATION

(a) Install the oil pump assembly to the torque converter assembly.

(b) Check that the front oil pump drive gear rotates smoothly.

(c) Remove the oil pump assembly from the torque converter assembly.

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT OIL PUMP BODY O-RING (a) Remove the front oil pump body O-ring from the oil pump assembly. 2. SECURE OIL ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT OIL PUMP OIL SEAL (a) Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body sub-assembly. SST: 09350-30020 ...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (See page ) 2. REMOVE HEADLIGHT ASSEMBLY (a) Apply protective tape around the headlight ...

Removal
REMOVAL PROCEDURE 1. REMOVE STEERING PAD (See page ) 2. REMOVE STEERING WHEEL ASSEMBLY 3. REMOVE LOWER STEERING COLUMN COVER 4. REMOVE UPPER STEERING COLUMN COVER 5. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR (a) Slide the slider and disconnect the airbag connector ...

Open in Front Floor Electrical Key Oscillator Circuit (B27A5)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the No. 1 indoor electrical key antenna assembly (front floor). For the No. 1 indoor electrical key antenna assembly (front floor) to detect when the electrical key transmitter su ...

2015-2022 © Copyright www.luting.site