Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR AXLE SHAFT

(a) Using a dial indicator, measure the runout of the shaft and flange.

(a) Using a dial indicator, measure the runout of the shaft and flange.

Maximum runout:

Shaft runout: 1.5 mm (0.0591 in.)

Flange runout: 0.05 mm (0.0020 in.)

If the rear axle shaft or flange is damaged or worn, or the runout is greater than the maximum, replace the rear axle shaft.

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR AXLE SHAFT SNAP RING (a) Using a snap ring expander, remove the snap ring. 2. REMOVE REAR AXLE SHAFT (a) Using SST and press, remove the rear axle shaft. ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, mak ...

Other materials:

A-TRAC Indicator Light Remains ON
DESCRIPTION This is the A-TRAC main switch circuit. When the A-TRAC switch is turned on with the transfer in L4, the A-TRAC function is available and the A-TRAC indicator light illuminates. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (master ...

Acceleration Sensor Internal Circuit (C1419,C1435)
DESCRIPTION The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 ...

Installation
INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONER PRESSURE SENSOR (a) Remove the vinyl tape from the air conditioner tube and accessory assembly and connecting part of the air conditioner pressure sensor. (b) Apply sufficiently compressor oil to a new O-ring and fitting surface of the air co ...

2015-2022 © Copyright www.luting.site