INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONER PRESSURE SENSOR
(a) Remove the vinyl tape from the air conditioner tube and accessory assembly and connecting part of the air conditioner pressure sensor.
(b) Apply sufficiently compressor oil to a new O-ring and fitting surface of the air conditioner pressure sensor.
Compressor oil:
PSD1 or equivalent
NOTICE:
Keep the O-rings and O-ring fitting surfaces free of foreign matter.
(c) Using a 27 mm deep socket wrench, install the air conditioner pressure sensor. Text in Illustration
Torque: 11 NВ·m {110 kgfВ·cm, 8 ftВ·lbf} |
|
(d) Connect the connector.
2. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
3. WARM UP ENGINE
4. INSPECT FOR REFRIGERANT LEAK
Tire Pressure Warning Receiver
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. SEPARATE ROOF HEADLINING ASSEMBLY (for Double Cab)
(See page )
2. SEPARATE ROOF HEADLINING ASSEMBLY (for Access Cab)
(See page )
3. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
(a) Disconnect the connector.
(b) ...
Transfer Shift Motor Control Circuit Low (P17A9)
DESCRIPTION
This DTC is output when a short to ground in the transfer shift motor and A.D.D.
shift motor drive circuit is detected.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P17A9
Transfer Shift Motor Contr ...
Input Speed Sensor Circuit No Signal (P0717,P07BF,P07C0)
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input turbine
speed of the transmission. By comparing the input turbine speed signal (NT) with
the output shaft speed sensor signal (SP2), the ECM detects the shift timing of
the gears and appropriately controls ...