Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Installation

INSTALLATION

PROCEDURE

1. SET NO. 1 CYLINDER TO TDC/COMPRESSION

2. INSTALL CAMSHAFT TIMING GEAR BOLT

2. INSTALL CAMSHAFT TIMING GEAR BOLT

NOTICE:

There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

*a

Identification Mark Stamp

Identification Mark

Item

Identification Mark Stamp

Intake Side

Exhaust Side

Type A

A

B

Type B

D

G

(a) Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

(b) Temporarily install the camshaft timing gear bolt.

Torque:

10 NВ·m {102 kgfВ·cm, 7 ftВ·lbf}

HINT:

Make sure that the flange part of the camshaft timing gear bolt is directly contacting the camshaft timing gear assembly.

(c) Loosen the camshaft timing gear bolt 60 to 180В°.

(d) Using SST, hold the crankshaft pulley assembly.

SST: 09213-54015

91651-60855

SST: 09330-00021

(e) Tighten the camshaft timing gear bolt.

Torque:

for Type A :

120 NВ·m {1224 kgfВ·cm, 89 ftВ·lbf}

for Type B :

95 NВ·m {969 kgfВ·cm, 70 ftВ·lbf}

3. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

(See page 4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY )

4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Torque:

30 NВ·m {306 kgfВ·cm, 22 ftВ·lbf}

5. INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

Torque:

30 NВ·m {306 kgfВ·cm, 22 ftВ·lbf}

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts. PROCEDURE 1. REMOVE NO. 2 ENGINE UNDER C ...

Camshaft Oil Control Valve(for Exhaust Side Of Bank 2)
...

Other materials:

System Description
SYSTEM DESCRIPTION 1. FUNCTION OF MAIN COMPONENTS Component Function Vertical mirror motor Moves the mirror surface vertically in accordance with the vertical mirror motor outer mirror switch assembly operation. Horizontal mirr ...

Voice Guidance does not Function
PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG CHANGE THE VOICE GUIDANCE SETTING TO ON OK ...

Front Occupant Classification Sensor LH Collision Detection (B1785)
DESCRIPTION DTC B1785 is set when the occupant detection ECU receives a collision detection signal, which is sent by the occupant classification sensor front LH when an accident occurs. DTC B1785 is also set when the front seat with adjuster frame assembly RH is subjected to a strong impact, ...

2015-2023 © Copyright www.luting.site