Toyota Tacoma 2015-2018 Service Manual: Lubrication System
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL LEVEL
(a) Warm up the engine, and then stop the engine and wait for 5 minutes.
(b) Check that the engine oil level is between the low level and full level marks on the dipstick.
If low, check for leakage and add engine oil up to the full level mark.
NOTICE:
Do not fill engine oil above the full level mark.
2. INSPECT OIL QUALITY
(a) Check the engine oil for deterioration, water contamination, discoloration or thinning.
If the quality is visibly poor, replace the engine oil and oil filter element
(See page 
).
3. INSPECT OIL PRESSURE
(a) Remove the oil pressure switch (See page
).
|
(b) Install an oil pressure gauge. Text in Illustration
|
|
(c) Warm up the engine.
(d) Inspect the oil pressure.
Standard Oil Pressure:
|
Condition |
Specified Condition |
|---|---|
|
Idling |
29 kPa (0.3 kgf/cm2, 4.2 psi) or higher |
|
3000 rpm |
294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi) |
If the pressure is not as specified, check the oil pump (See page
).
(e) Remove the oil pressure gauge.
(f) Install the oil pressure switch (See page
).
Engine Oil Cooler
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT OIL COOLER ASSEMBLY
(a) Check the oil cooler assembly for damage a ...
Other materials:
Transmitter ID not Received in Main Mode (C2126/26)
DESCRIPTION
After all transmitter IDs are registered, DTC C2126/26 is stored in the tire
pressure warning ECU and receiver and the tire pressure warning light blinks for
1 minute and then illuminates.
When the tire pressure warning ECU and receiver successfully receives radio waves
from all ...
System Description
SYSTEM DESCRIPTION
1. ENGINE IMMOBILISER SYSTEM DESCRIPTION
(a) The engine immobiliser system determines whether or not to enable starting
of the SFI system based on a comparison of the key ID code and the vehicle pre-registered
code. The engine immobiliser system compares the vehicle certific ...
Rear Door Black Out Tape
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REPAIR INSTRUCTION
2. INSTALL NO. 2 BLACK OUT TAPE
(a) Refer ...