Toyota Tacoma 2015-2018 Service Manual: Oil Pressure Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
|
(a) Disengage the clamp and disconnect the engine oil pressure switch connector. |
|
|
(b) Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly. |
|
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disconnect the engine oil pressure switch connector.
(b) Start the engine.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
1 - Body ground |
Engine stopped |
Below 1 О© |
|
Engine idling |
10 kО© or higher |
If the result is not as specified, replace the engine oil pressure switch assembly.
(d) Connect the engine oil pressure switch connector.
Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
NOTICE:
Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
(b) Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Torque:
15 NВ·m {153 kgfВ·cm, 11 ftВ·lbf}
NOTICE:
Do not start the engine within 1 hour of installation.
(c) Connect the engine oil pressure switch connector and attach the clamp.
2. INSPECT FOR ENGINE OIL LEAK
3. INSPECT ENGINE OIL LEVEL
Oil Level Sensor
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in th ...
Oil Pump
...
Other materials:
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE FOG LIGHT BULB
(a) Turn the fog light bulb in the direction indicated by the arrow in
the illust ...
Power Supply Drive Circuit (C1257)
DESCRIPTION
The motor relay (semiconductor relay) is built into the hydraulic brake booster
and drives the pump motor based on a signal from the skid control ECU (master cylinder
solenoid).
DTC No.
DTC Detecting Condition
Trouble Areas
C1257
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. INSTALL FRONT SEAT INNER BELT ASSEMBLY
(a) for Driver Side:
(1) Install t ...