Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT CAMSHAFT TIMING GEAR BOLT

(a) Remove the camshaft timing oil control solenoid assembly (See page ).

(b) Check that the plunger strokes when the plunger in the center of the camshaft timing gear bolt is pressed.

Standard stroke:

4.5 mm (0.177 in.) or more

HINT:

When pressing the plunger, there is a stepped feeling but this is not a malfunction.

If the result is not as specified, replace the camshaft timing gear bolt.

(c) Install the camshaft timing oil control solenoid assembly (See page Installation ).

Components
COMPONENTS ILLUSTRATION ...

Installation
INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC/COMPRESSION 2. INSTALL CAMSHAFT TIMING GEAR BOLT NOTICE: There are different types of camshaft timing gear bolts. Make sure to check the i ...

Other materials:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY (a) Install the rear seatback hinge sub-assembly with the 2 bolts. Torque: 30 NВ·m {306 kgfВ·cm, 22 ftВ·lbf} 2. INSTALL REAR SEATBACK ASSEMBLY (a) Install the rear seatback assembly with the 2 bolts. Torque: 37 NВ·m {377 k ...

Lost Communication with ECM / PCM "A" (U0100,U0129,U0142,U0151,U0163,U023A,U1104)
DESCRIPTION The combination meter communicates with the ECM, skid control ECU, power steering ECU, main body ECU (multiplex network body ECU), airbag sensor assembly, navigation receiver assembly*1, radio and display receiver assembly*2, Forward recognition camera*3 and Millimeter wave radar ...

Precaution
PRECAUTION 1. BASIC REPAIR HINT (a) HINTS ON OPERATIONS 1 Attire Always wear a clean uniform. A hat and safety shoes must be worn. 2 Vehicle protection Prepare a grille cover, fe ...

2015-2023 © Copyright www.luting.site