Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT CAMSHAFT TIMING GEAR BOLT

(a) Remove the camshaft timing oil control solenoid assembly (See page ).

(b) Check that the plunger strokes when the plunger in the center of the camshaft timing gear bolt is pressed.

Standard stroke:

4.5 mm (0.177 in.) or more

HINT:

When pressing the plunger, there is a stepped feeling but this is not a malfunction.

If the result is not as specified, replace the camshaft timing gear bolt.

(c) Install the camshaft timing oil control solenoid assembly (See page Removal ).

Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts. PROCEDURE 1. REMOVE NO. 2 ENGINE UNDER C ...

Other materials:

Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441/41)
DESCRIPTION This No. 2 air conditioning radiator damper servo sub-assembly (for front passenger side air mix) is controlled by the air conditioning amplifier assembly and moves the air mix damper (for front passenger side) to the desired position. DTC No. DTC Detection Co ...

All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
DESCRIPTION The main body ECU (multiplex network body ECU) receives switch signals from the door control switch assembly on the front passenger door and activates the door lock motor on each door according to these signals. WIRING DIAGRAM PROCEDURE 1. READ VALUE USIN ...

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. When removing the No. 2 front wheel opening extension pad or No. 1 front wheel opening extension pad or front wheel opening extension pad, ...

2015-2023 © Copyright www.luting.site