Toyota Tacoma 2015-2018 Service Manual: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Seat heater does not operate for driver side and front passenger side seat |
Harness and connector |
- |
|
Air conditioning control assembly |
|
|
|
Air conditioning amplifier assembly |
|
|
|
Front seat heater does not operate (for driver) |
Driver side seat heater does not operate |
|
|
Air conditioning control assembly |
|
|
|
Front seat cushion heater assembly LH |
|
|
|
Front seatback heater assembly LH |
|
|
|
Wire harness or connector |
- |
|
|
Front seat heater does not operate (for front passenger) |
Front passenger side seat heater does not operate |
|
|
Air conditioning control assembly |
|
|
|
Front seat cushion heater assembly RH |
|
|
|
Front seatback heater assembly RH |
|
|
|
Wire harness or connector |
- |
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditi ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
(a) Disconnect the A36 air conditioning amplifier assembly connector.
(b) Measure the voltage and resistance according to the value(s ...
Other materials:
Driver Side Door Entry Unlock Function does not Operate
DESCRIPTION
If the entry unlock function does not operate for the driver door only, but the
entry lock function operates, the request code is being transmitted properly from
the driver door. In this case, there may be a problem related to the touch sensor
(connection between the certification ...
Yaw Rate Sensor Malfunction (C1436)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via the CAN communication
system.
The airbag sensor assembly has a built-in yaw rate sensor and detects the vehicle
condition.
If there is trouble i ...
Front Upper Suspension Arm
Components
COMPONENTS
ILLUSTRATION
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE FRONT SUSPENSION UPPER ARM BUSH
(a) Using a hammer and chisel, raise the flange of the bushing diagonally as
shown in the illustration.
(b) Using SST and a press, remove the front suspension u ...