Toyota Tacoma 2015-2018 Service Manual: Ptc Heater Assembly

Toyota Tacoma 2015-2018 Service Manual / Air Conditioning / Ptc Heater Assembly

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

PROCEDURE

1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY )

2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY

3. REMOVE AIR DUCT ASSEMBLY

4. REMOVE QUICK HEATER ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 2 screws and quick heater assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT QUICK HEATER ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a	Component without harness connected (Quick Heater Assembly)

Standard Resistance:

Tester Connection (Terminal Code)	Switch Condition	Specified Condition
1(B) - 2(E)	Always	Below 1 О©
3(B) - 2(E)	Always	Below 1 О©
3(B) - 4(E)	Always	Below 1 О©
5(B) - 4(E)	Always	Below 1 О©

If the specified condition is not met, replace the quick heater assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL QUICK HEATER ASSEMBLY

(a) Install the quick heater assembly with the 2 screws.

(b) Connect the connector.

2. INSTALL AIR DUCT ASSEMBLY

3. INSTALL INSTRUMENT LOWER PANEL ASSEMBLY

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page Ptc Heater Relay )

Magnetic Clutch Relay

Inspection INSPECTION PROCEDURE 1. INSPECT MAGNET-CLUTCH RELAY (a) Check the resistance. (1) Using an ohmmeter, measure the resistance between the terminals. Standard: ...

Ptc Heater Relay

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT PTC HEATER RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) i ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT TRANSMISSION WIRE (a) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (Transmission Wire) Standard Resistance: ...

Front Radar Sensor Incorrect Axial Gap (C1A11,C1A14)
DESCRIPTION When the system determines that the vehicle is driving straight ahead based on signals from the yaw rate and acceleration sensor (airbag sensor assembly), etc., the millimeter wave radar sensor assembly performs self-diagnosis to check if the sensor beam axis is misaligned. C1A11 ...

Antenna Coil Open / Short (B2784)
DESCRIPTION When an open or short circuit is detected in the antenna coil built into the transponder key coil, the transponder key ECU assembly stores this DTC. DTC No. DTC Detection Condition Trouble Area DTC Output Confirmation Operation ...