Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Ptc Heater Relay

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT PTC HEATER RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kО© or higher

3 - 5

Battery voltage applied to terminals 1 and 2

Below 1 О©

If the result is not as specified, replace the ptc heater relay.

Installation

INSTALLATION

PROCEDURE

1. INSTALL PTC HEATER RELAY

(a) Install the ptc heater relay.

Removal

REMOVAL

PROCEDURE

1. REMOVE PTC HEATER RELAY

(a) Remove the ptc heater relay.

Ptc Heater Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (See page ) 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY 3. REMOVE ...

Refrigerant Line
Components COMPONENTS ILLUSTRATION ...

Other materials:

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Clearance Warning ECU Assembly Destination information signal CAN Communication Line ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE ROOM LIGHT BRACKET (a) Disengage the guide to remove the room light bracket. 2. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (a) Remove the 2 bolts and sliding roof drive gear sub-assembly. ...

Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE CYLINDER AND PISTON (a) Check the cylinder bore and piston for rust and scoring. 2. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the pad lining thickness. Standard thickness: 11.5 mm (0.453 in.) Minimum thickness: 1.0 mm (0.0394 in.) ...

2015-2022 © Copyright www.luting.site