Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab)

Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

Click here 3. REMOVE COWL SIDE TRIM BOARD LH

3. REMOVE COWL SIDE TRIM BOARD LH

Click here 4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

Click here 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here 6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

Click here 7. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

7. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

Click here 8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

Click here 9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

(a) Disengage the 8 clips.

(b) Disconnect the connectors to remove the air conditioning control assembly.

10. REMOVE ENGINE SWITCH

Click here 11. REMOVE TRANSFER POSITION SWITCH (for 4WD)

11. REMOVE TRANSFER POSITION SWITCH (for 4WD)

Click here Air Conditioning Pressure Sensor

Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSFER POSITION SWITCH (for 4WD) Click here 2. INSTALL ENGINE SWITCH Click here 3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (a) Connect the connectors. ...

Air Conditioning Pressure Sensor
...

Other materials:

Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1) (P0748)
DESCRIPTION Changing from 1st to 6th is performed by the ECM turning shift solenoid valves SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be operated ...

Transfer System
Precaution PRECAUTION Before disassembly, clean the transfer assembly and remove any deposited sand and mud to prevent it from entering the transfer during disassembly and assembly. When removing any light alloy parts such as the transfer covers, do not pry them off with a ...

Stop Light Switch OFF Stuck Malfunction (C1426)
DESCRIPTION The skid control ECU (brake actuator assembly) inputs the stop light signal and brake operation condition. When the brake pedal is depressed and the stop light switch signal is not input, C1426 is output. DTC No. Detection Item DTC Detection Conditi ...

2015-2022 © Copyright www.luting.site