Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE REFRIGERANT FROM REFRIGERATION SYSTEM

2. REMOVE AIR CONDITIONER PRESSURE SENSOR

2. REMOVE AIR CONDITIONER PRESSURE SENSOR

(a) Disconnect the connector.

(b) Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor.

Text in Illustration

*a

Turn

*b

Hold

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONER PRESSURE SENSOR (for Automatic Air Conditioning System) (a) Check the wire harness. (1) Disconnect the A34 air conditioner pressure senso ...

Air Conditioning System(for Automatic Air Conditioning System)
...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). NOTICE: After turning the ign ...

Reassembly
REASSEMBLY PROCEDURE 1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG (a) Provisionally tighten the bleeder plug to the disc brake cylinder. (b) Install the bleeder plug cap onto the bleeder plug. 2. INSTALL PISTON SEAL (a) Apply lithium soap base glycol grease to 4 new piston s ...

Communication Error from VSC to ECM (P1630)
DESCRIPTION The skid control ECU (brake actuator assembly) sends signals such as cruise control cancel signals and brake demand response signals to the ECM when the dynamic radar cruise control system is operating. DTC No. Detection Item DTC Detection Condition ...

2015-2022 © Copyright www.luting.site