Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab)

2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab) 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

3. REMOVE COWL SIDE TRIM BOARD LH 3. REMOVE COWL SIDE TRIM BOARD LH

3. REMOVE COWL SIDE TRIM BOARD LH

4. REMOVE CENTER INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY 4. REMOVE CENTER INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

4. REMOVE CENTER INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH 6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH

6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH

7. REMOVE COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR 7. REMOVE COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR

7. REMOVE COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR

(a) Disengage the 2claws to disconnect the cooler (room temperature sensor) thermistor.

(b) Disconnect the connector.

(c) Disconnect the cooler air hose to remove the cooler (room temperature sensor) thermistor.

Inspection
INSPECTION PROCEDURE 1. INSPECT COOLER (ROOM TEMPERATURE. SENSOR) THERMISTOR (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Text i ...

Installation
INSTALLATION PROCEDURE 1. INSTALL COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR (a) Connect the cooler air hose. (b) Connect the connector. (c) Engage the 2 claws to connect the cooler (room temper ...

Other materials:

Front Radar Sensor Incorrect Axial Gap (C1A11,C1A14)
DESCRIPTION When the system determines that the vehicle is driving straight ahead based on signals from the yaw rate and acceleration sensor (airbag sensor assembly), etc., the millimeter wave radar sensor assembly performs self-diagnosis to check if the sensor beam axis is misaligned. C1A11 ...

Pressure Sensor Circuit (B1423/23)
DESCRIPTION This DTC is stored if refrigerant pressure on the high pressure side is extremely low (176 kPa (1.8 kgf/cm2, 26 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The air conditioner pressure sensor, which is installed on the pipe on the high pressure side ...

Network Gateway Ecu
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL NETWORK GATEWAY ECU (a) Install the network gateway ECU with the bolt. Torque: 3.0 NВ·m {31 kgfВ·cm, 27 inВ·lbf} (b) Connect the connector. 2. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY (See page ) R ...

2015-2022 © Copyright www.luting.site