Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Repair

REPAIR

PROCEDURE

1. STEERING OFF CENTER REPAIR PROCEDURE

(a) Check if the steering wheel is off center.

(1) Apply masking tape to the top center of the steering wheel and upper steering column cover.

Text in Illustration

*1

Steering Wheel

*2

Upper Steering Column Cover

*a

Masking Tape

(2) Drive the vehicle in a straight line for 100 m (328 ft.) at a constant speed of 56 km/h (35 mph), and hold the steering wheel to maintain the course.

(3) Draw a line on the masking tape as shown in the illustration.

Text in Illustration

*1

Steering Wheel

*2

Upper Steering Column Cover

*a

Marked Line

(4) Turn the steering wheel to its straight position.

HINT:

Look at the upper surface of the steering wheel, steering spoke and SRS airbag line to find the center position.

(5) Draw a new line on the masking tape on the steering wheel as shown in the illustration.

Text in Illustration

*1

Steering Wheel

*2

Upper Steering Column Cover

*a

Marked Line

(6) Measure the distance between the 2 lines on the masking tape of the steering wheel.

(7) Convert the measured distance to the steering angle.

HINT:

  • Measured distance 1 mm (0.0394 in.) = Steering angle of approximately 1В°.
  • Make a note of the steering angle.

(b) Adjust the steering angle.

(1) Draw a line on the RH and LH tie rods and on the RH and LH rack ends which can easily be seen.

Text in Illustration

*a

Matchmark

(2) Using a paper gauge, measure the distance from a RH and LH tie rod ends to the rack end screws.

HINT:

  • Measure both the RH and LH sides.
  • Make a note of the measured values.

(3) Remove the RH and LH boot clips from the rack boots.

(4) Loosen the RH and LH lock nuts.

(5) Turn the RH and LH rack ends by the same amount (but in different directions) according to the steering angle.

HINT:

One 360В° turn of a rack end (1.5 mm (0.0591 in.) horizontal movement) is equal to a 12В° change in steering angle.

(6) Tighten the RH and LH lock nuts.

Torque:

56 NВ·m {566 kgfВ·cm, 41 ftВ·lbf}

NOTICE:

Make sure that the difference in length between the RH and LH tie rod ends and rack end screws is less than 1.5 mm (0.059 in.).

(7) Install the RH and LH boot clips.

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order ...

Air Conditioning
...

Other materials:

Center Differential Lock Position Switch (C1282)
DESCRIPTION DTC C1282 is stored only in test mode. DTC Code DTC Detection Condition Trouble Area C1282 Stored during test mode. Harness or connector Transfer system Skid control ECU (master cylinder sole ...

Cellular Phone cannot Send/Receive
PROCEDURE 1. CHECK "Bluetooth" SETTINGS (a) Check if the cellular phone is registered as a connected device and the "Bluetooth" settings are correct. OK: The cellular phone is registered as a connected device and "Bluetooth" settin ...

Open in Occupant Classification ECU Battery Positive Line (B1794)
DESCRIPTION DTC B1794 is set when a malfunction is detected in the occupant detection ECU. DTC No. DTC Detections Conditions Trouble Areas B1794 Occupant detection ECU circuit malfunction Occupant detection ECU malfuncti ...

2015-2022 © Copyright www.luting.site