Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Terminals Of Ecm

TERMINALS OF ECM

1. CHECK ECM

HINT:

HINT:

The standard normal voltage between each pair of ECM terminals is shown in the table below. The appropriate conditions for checking each pair of terminals are also indicated. The result of checks should be compared with the standard normal voltage for that pair of terminals, displayed in the Specified Condition column. The illustration above can be used as a reference to identify the ECM terminal locations.

Terminal No. (Symbol)

Wiring Color

Terminal Description

Condition

Specified Condition

E14-2 (BATT) - E11-1 (E1)

L - W-B

Battery (for measuring battery voltage and for ECM memory)

Always

11 to 14 V

E11-1 (E1) - Body ground

W-B - Body ground

Ground circuit of ECM

Always

Below 1 О©

E9-34 (LIN) - Body ground

L - Body ground

LIN communication line

Ignition switch off

10 kО© or higher

Diagnosis System
DIAGNOSIS SYSTEM 1. DLC3 (Data Link Connector 3) (a) Check the DLC3 (See page ). 2. BATTERY VOLTAGE Standard voltage: 11 to 14 V If the voltage is below 11 V, replace or recharge the battery. ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Engine / Trouble ...

Other materials:

Inverter Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT INVERTER RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition ...

Open or Short in Front Speed Sensor RH Circuit (C1405,C1406)
DESCRIPTION Refer to DTCs C1401 and C1402 (See page ). DTC Code DTC Detection Condition Trouble Area C1405 C1406 Either condition is met: An open in the speed sensor signal circuit continues for 0.5 seconds or mor ...

Installation
INSTALLATION PROCEDURE 1. INSTALL OIL COOLER TUBE (a) Install the oil cooler tube to the vehicle body with the 2 bolts. Torque: 28 NВ·m {286 kgfВ·cm, 21 ftВ·lbf} 2. INSTALL NO. 4 OIL COOLER INLET HOSE AND NO. 4 OIL COOLER OUTLET HOSE NOTICE: When connecting the hoses to the tube, su ...

2015-2022 © Copyright www.luting.site